Table of Contents
Advertisement
show interface cable qos paramset
show interface cable qos paramset
To display the attributes of the service flow QoS parameter set, use the show interface cable qos
paramset command in privileged EXEC mode.
Parameter sets that contain a service-class name string are in an "unexpanded" state and serve as
Note
provisioning envelopes of class-based service flows. The actual attributes of such parameter sets depend
on the service class that is referenced at the time the parameter sets are expanded.
Syntax Description
slot/port
slot/subslot/port
paramset-index
verbose
Command Modes
Privileged EXEC
Command History
Release
12.1(4)CX
12.2(4)BC1
Examples
The following example shows typical output for the show interface cable qos paramset command:
Router# show interface c6/0 qos paramset
Index Name
1
2
3
4
128
129
Router#
Cisco Broadband Cable Command Reference Guide
3-226
show interface cable {slot/port | slot/subslot/port} qos paramset [paramset-index] [verbose]
Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
•
•
•
Identifies the desired service template index (1 to 255).
Displays full details about the QoS parameter set.
Modification
This command replaces the
DOCSIS 1.1 operation.
Support was added to the Release 12.2 BC train.
Dir
US
DS
US
DS
US
DS
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
show cable qos profile
Sched
Prio MaxSusRate
BE
0
64000
BE
0
1000000
BE
7
1000000
BE
0
10000000
BE
7
1000000
BE
0
10000000
Chapter 3
Cisco CMTS Show Commands
command for
MaxBurst
MinRsvRate
0
0
0
0
1522
0
3044
0
1522
0
3044
0
OL-1581-08
Advertisement
Table of Contents
