Table of Contents
Advertisement
cable telco-return spd service-provider
cable telco-return spd service-provider
To include the service provider name in the SPD, use the cable telco-return service-provider command
in cable interface configuration mode. To remove the parameter from the SPD, use the no form of this
command.
Syntax Description
spd-number
spd-string
Defaults
No default behavior or values
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the Service Provider Name parameter for the specified SPD in the Telephony
Channel Descriptor (TCD) messages.
This command is available only in images that support telco-return. These images have a "t" as part of
Note
the image name.
Examples
The following example shows the service provider name being set to "san_jose" for SPD 2:
router(config-if)# cable telco-return spd 2 service-provider san_jose
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
cable telco-return spd dhcp-
authenticate
Cisco Broadband Cable Command Reference Guide
2-274
cable telco-return spd spd-number service-provider spd-string
no cable telco-return spd spd-number service-provider
Service provider descriptor number for which this parameter is set.
Valid range is 1 through 5.
Alphanumeric string that identifies the service provider.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Indicates that telco-return CMs must use a specific DHCP server.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
