Table of Contents
Advertisement
debug cable dynamic-secret
debug cable dynamic-secret
To display debugging messages for the Dynamic Shared Secret feature, use the debug cable
dynamic-secret command in privileged EXEC mode. To stop the display of debugging messages, use
the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
Because this command can produce a large volume of debug information, use this command only when
Tip
you have also enabled debugging for a particular interface or MAC address, using the debug cable
interface and debug cable mac-address commands, respectively.
Examples
The following example shows how to enable debugging output using the debug cable dynamic-secret
command:
Router# debug cable dynamic-secret
CMTS dynamic-secret debugging is on
Router#
The following example shows typical output for a cable modem that is reset and reregisters while the
Dynamic Shared Secret feature is enabled:
02:15:59: Closing file for modem 00c0.2345.6789: New modem state from resetting to offline
02:16:10: Found file name in BOOT_FILE option
02:16:10: Parsing IP address from 10.10.35.200, len 10..
Setting 10 bytes to PAD
02:16:10: Config file for 00c0.2345.6789 set to 10.8.35.200:/cm/UBsgvca698. Was
10.10.35.200:/cm/config.cm
Cisco Broadband Cable Command Reference Guide
5-24
debug cable dynamic-secret
no debug cable dynamic-secret
Modification
This command was introduced for Cisco uBR7100 series, Cisco uBR7200
series, and Cisco uBR10012 routers.
Chapter 5
Cisco CMTS Debugging Commands
Got 10.10.35.200
OL-1581-08
Advertisement
Table of Contents
