Table of Contents
Advertisement
debug hccp timing
debug hccp timing
To display debug messages for the timing of HCCP events, use the debug hccp timing command in
privileged EXEC mode. To disable the debug message output, use the no form of this command.
Syntax Description
if-config
Command Modes
Privileged EXEC
Command History
Release
12.1(3a)EC
12.2(4)XF1,
12.2(4)BC1
12.2(11)BC1
12.2(15)BC1
Usage Guidelines
You must activate the
generate any debug message output.
Examples
The following example shows typical output for the debug hccp timing command:
Router# debug hccp events
Router# debug hccp timing
HCCP timing measurement debugging is on
May 31 10:21:07.609 HCCP P is busy. Deactivating 1 6
May 31 10:21:07.609 HCCP P is busy. Deactivating 2 6
May 31 10:21:08.705 HCCP hwif_goingdown for Cable8/1/0. Deactivate 1 6
May 31 10:21:08.705 HCCP hwif_goingdown for Cable8/1/1. Deactivate 2 6
May 31 10:21:08.773 HCCP 2 6 Working: become standby - 68 msec
May 31 10:21:08.793 HCCP 1 6 Working: become standby - 20 msec
May 31 10:21:10.730 HCCP 1 1 Working: turn on "uc" - 8 msec
May 31 10:21:10.730 HCCP 1 1 Working: turn on "nru" - 0 msec
May 31 10:21:10.734 HCCP 1 1 Working: become active - 4 msec
May 31 10:21:10.774 HCCP 2 1 Working: turn on "uc" - 52 msec
May 31 10:21:10.774 HCCP 2 1 Working: turn on "nru" - 0 msec
May 31 10:21:10.774 HCCP 2 1 Working: become active - 0 msec
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 1
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 6
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 3
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 2
Cisco Broadband Cable Command Reference Guide
5-112
debug hccp timing [if-config]
no debug hccp timing [if-config]
(Optional) Displays debugging messages showing the timing of the
reconfiguration of cable interfaces during HCCP redundancy operations.
Modification
This command was introduced.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router.
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router.
The if-config option was added.
debug hccp events
Chapter 5
command before the debug hccp timing command will
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
