Table of Contents
Advertisement
show packetcable global
Table 3-64 show packetcable global Field Display
Field
Enabled
Element ID
Max Gates
Allow non-PacketCable
UGS or Not Allow non-
PacketCable UGS
Default Timer value
Related Commands
Command
packetcable
packetcable authorize
vanilla-docsis-mta
packetcable element-
id
packetcable gate
maxcount
packetcable timer
show packetcable gate
show packetcable gate
counter commit
Cisco Broadband Cable Command Reference Guide
3-258
Description
Displays whether PacketCable operation is enabled or disabled. (See the
packetcable
Displays the Element ID for the CMTS. If you do not manually configure
this parameter with the
random value between 0 and 99,999 when PacketCable operations is
enabled.
Displays the maximum number of gates that the CMTS supports. (See the
packetcable gate maxcount
Displays whether non-PacketCable, DOCSIS-style UGS service flows are
allowed when PacketCable operations are enabled. (See the
authorize vanilla-docsis-mta
Displays the current values of the following DQoS timers that the CMTS
maintains. (See the
T0
T0 specifies the amount of time that a gate ID can remain allocated without
any specified gate parameters. The timer begins counting when a gate is
allocated with a Gate-Alloc command. The timer stops when a Gate-Set
command marks the gate as Authorized. If the timer expires without a Gate-
Set command being received, the gate is deleted.
The valid range is 1 to 1,000,000,000 milliseconds, with a default value of
30000 milliseconds (30 seconds).
T1
T1 specifies the amount of time that an authorization for a gate can remain
valid. It begins counting when the CMTS creates a gate with a Gate-Set
command and puts the gate in the Authorized state. The timer stops when the
gate is put into the committed state. If the timer expires without the gate
being committed, the CMTS must close the gate and release all associated
resources.
The valid range is 1 to 1,000,000,000 milliseconds, with a default value of
200000 milliseconds (200 seconds).
Description
Enables PacketCable operations on the Cisco CMTS.
Allows Unsolicited Grant Service (UGS) service flows without a proper
PacketCable gate ID when PacketCable operations are enabled on the
Cisco CMTS.
Configures the PacketCable Event Message Element ID on the
Cisco CMTS.
Changes the maximum number of PacketCable gate IDs in the gate database
on the Cisco CMTS.
Changes the value of the different PacketCable DQoS timers.
Displays information about one or more gates in the gate database.
Displays the total number of committed gates since system reset or since the
counter was last cleared.
command.)
packetcable element-id
command.)
command.)
packetcable timer
Chapter 3
Cisco CMTS Show Commands
command, it defaults to a
packetcable
command.)
OL-1581-08
Advertisement
Table of Contents
