show interface cable privacy
show interface cable privacy
To display baseline privacy information, use the show interface cable privacy command in privileged
EXEC mode.
Syntax Description
slot/port
slot/subslot/port
tek
kek
Command Modes
Privileged EXEC
Command History
Release
11.3(5)NA
Usage Guidelines
This command appears and is available only in images that support BPI and BPI+ encryption.
Examples
The following are sample outputs for the show interface cable privacy command:
router# show interface cable 3/0 privacy tek
Configured TEK life-time value = 56000
Configured TEK grace-time value = 900
router# show interface cable 3/0 privacy kek
Configured KEK life-time value = 750000
Configured KEK grace-time value = 800
Table 3-56
Cisco Broadband Cable Command Reference Guide
3-224
show interface cable {slot/port | slot/subslot/port} privacy {tek | kek}
Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0 or
1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
•
slot = 5 to 8
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
Displays the traffic encryption key values.
Displays the key encryption key values.
Modification
This command was introduced.
describes the fields shown in the show interface cable privacy displays.
Chapter 3
Cisco CMTS Show Commands
OL-1581-08