Table of Contents
Advertisement
show interface cable
Table 3-50 show interface cable Field Descriptions (continued)
Field
output errors
collisions
interface resets
output buffer failures
output buffer swapped out
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show commands using the exec prompt timestamp command in line configuration mode.
Related Commands
Command
show interface cable
downstream
show interface cable
sid
show interface cable
signal-quality
show interface cable
upstream
Cisco Broadband Cable Command Reference Guide
3-208
Description
Sum of all errors that prevented the final transmission of packets
out of the interface being examined.
Not applicable.
Number of times an interface has been completely reset.
Number of times the output buffer has failed.
Number of times the output buffer has been swapped out.
Description
Displays information about the downstream on the cable interface.
Displays information by service identifier (SID) of each CM on the network.
Displays information about the cable signal quality.
Displays information about one or all upstreams on the cable interface.
Chapter 3
Cisco CMTS Show Commands
OL-1581-08
Advertisement
Table of Contents
