Table of Contents
Advertisement
maintenance-mode
maintenance-mode
To configure the PRE1 modules on the router for maintenance mode, use the maintenance-mode
command in redundancy configuration mode. To return to normal operations, use the no form of this
command.
Syntax Description
This command has no keywords or arguments.
Defaults
Normal operations (no maintenance-mode)
Command Modes
Redundancy configuration
Command History
Release
12.2(4)XF
Usage Guidelines
When the Cisco uBR10012 router is configured with redundant PRE1 modules, the active PRE1 module
automatically synchronizes the configuration, network state information, and other information with the
standby PRE1 module, so that if a switchover occurs, the standby module can restore normal operations
quickly. You can use the maintenance-mode command to disable this automatic synchronization of the
PRE1 modules, and to disable the reporting of any faults on the standby module to the active module.
Note
The maintenance-mode command disables the ability of the Cisco uBR10012 router to switchover
PRE1 modules and should be used only while upgrading the router or troubleshooting network problems.
Examples
The following example shows how to disable the automatic PRE1 module synchronization on the
Cisco uBR10012 router and enter maintenance mode:
Router# config t
Router(config)# redundancy
Router(config-r)# maintenance-mode
Router(config-r)# exit
Router(config)#
The following example shows how to leave maintenance mode and return to normal operations, which
includes the automatic synchronization of the PRE1 modules:
Router# config t
Router(config)# redundancy
Router(config-r)# no maintenance-mode
Router(config-r)# exit
Router(config)#
Cisco Broadband Cable Command Reference Guide
4-30
maintenance-mode
no maintenance-mode
Modification
This command was introduced for the Cisco uBR10012 router.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
