Table of Contents
Advertisement
cable telco-return spd manual-dial
cable telco-return spd manual-dial
To enable the telco-return CM to operate in manual-dial mode, use the cable telco-return spd manual-
dial command in cable interface configuration mode. To restore the default value, use the no form of this
command.
Syntax Description
spd-number
Defaults
Manual-dial mode is disabled.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the Manual Dial vendor-specific parameter in the specified SPD in Telephony
Channel Descriptor (TCD) messages.
This command is available only in images that support telco-return. These images have a "t" as part of
Note
the image name.
Examples
The following example shows how to set manual-dial mode for SPD 1:
router(config-if)# cable telco-return spd 1 manual-dial
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
cable telco-return spd dhcp-
authenticate
Cisco Broadband Cable Command Reference Guide
2-264
cable telco-return spd spd-number manual-dial
no cable telco-return spd spd-number manual-dial
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Indicates that telco-return CMs must use a specific DHCP server.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
