Table of Contents
Advertisement
clear cable logging
clear cable logging
To remove all error messages about bad IP source addresses on the cable interfaces from the error log
buffer, use the clear cable logging badipsource command in privileged EXEC mode.
Syntax Description
This command has no keywords or arguments.
Command Modes
Privileged EXEC
Command History
Release
12.1(13)EC
12.2(11)CY
12.2(11)BC2
Usage Guidelines
The
error messages that the Cisco CMTS generates when it discovers a CM or CPE device using an
unauthorized IP address. When the buffer becomes full, the oldest messages are deleted to make room
for newer messages.
When you have viewed all of the error messages in the current buffer, use the clear cable logging
command to clear out the buffer to make room for newer messages.
Examples
The following example shows how to clear the log buffer that contains the bad IP source address error
messages:
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Router# clear cable logging badipsource
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Router#
Cisco Broadband Cable Command Reference Guide
2-376
clear cable logging badipsource
Modification
This command was introduced for the Cisco uBR7100 series and
Cisco uBR7200 series universal broadband routers.
Support was added for the Cisco uBR10012 universal broadband router.
Support was added to the Release 12.2 BC train for the Cisco uBR7100
series, Cisco uBR7200 series, and Cisco uBR10012 routers.
cable logging badipsource
Total buffer size (bytes): 1000000
Used buffer size (bytes) : 36968
Logged messages
Total buffer size (bytes): 1000000
Used buffer size (bytes) : 0
Logged messages
command creates a circular buffer that contains the BADIPSOURCE
: 231
: 0
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
