Cisco SR2016T-NA Reference Manual page 316

cable upstream docsis-mode
The following example shows the abbreviations needed to configure TDMA-only and mixed
TDMA/A-TDMA modes.
Router# config terminal
Router(config)# interface cable 4/0
Router(config-if)# cable upstream 0 docsis-mode tdm
%%Docsis mode set to DOCSIS1.0 TDMA Mode.
Router(config-if)# cable upstream 1 docsis-mode tdma-
%%Docsis mode set to DOCSIS2.0 Mixed Mode.
Router(config-if)#
Related Commands Command
cable modulation-profile
cable upstream channel-
width
cable upstream
equalization-coefficient
cable upstream maintain-
psd
cable upstream minislot-
size
cable upstream
modulation-profile
show cable modulation-
profile
show interface cable mac-
scheduler
Cisco Broadband Cable Command Reference Guide
2-304
Description
Defines a modulation profile for use on the router.
Specifies an upstream channel width for an upstream port.
Enables the use of a DOCSIS 1.1 pre-equalization coefficient on an
upstream.
Requires DOCSIS 2.0 CMs on an A-TDMA-only upstream to maintain
a constant power spectral density (PSD) after a modulation rate change.
Specifies the minislot size (in ticks) for a specific upstream interface.
Assigns one or two modulation profiles to an upstream port.
Displays the modulation profile information for a Cisco CMTS.
Displays the current time-slot scheduling state and statistics.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08