Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Modulation profiles must be first created using the cable modulation-profile command before they can
Tip
be assigned using the cable upstream modulation-profile command.
Examples
The following example assigns the primary modulation profile 2 and the secondary modulation profile 1
to upstream port 0 on the cable interface line card in slot 3. This automatically enables the Dynamic
Upstream Modulation feature for all CMs using that upstream.
Router(config)# interface cable 3/0
Router(config-if)# cable upstream 0 modulation-profile 2 1
Router(config-if)#
Related Commands
Command
cable modulation-profile
cable upstream hop-
priority
show cable modulation-
profile
OL-1581-08
Description
Creates a cable modulation profile.
Determines the order of the corrective actions to be taken when ingress
noise exceeds the allowable value for an upstream.
Displays the cable modulation profiles that have been created.
Cisco Broadband Cable Command Reference Guide
cable upstream modulation-profile
2-335
Advertisement
Table of Contents
