Table of Contents
Advertisement
show cable noise
show cable noise
To display cable noise statistics on a Cisco CMTS, use the show cable noise command in EXEC mode.
Syntax Description
slot/port
slot/subslot/port
Command Modes
EXEC
Command History
Release
12.0(4)XI
12.1(3a)EC1
Usage Guidelines
This command is not supported on Cisco IOS Release 12.1(3a)EC1 or later releases.
Examples
The following example shows how to display CM noise statistics:
Router# show cable 6/0 noise
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
Tip
show commands using the exec prompt timestamp command in line configuration mode.
Related Commands
Command
show cable modem
Cisco Broadband Cable Command Reference Guide
3-140
show cable {slot/port | slot/subslot/port} noise
Modification
This command was introduced.
This command was removed from the 12.1 EC release.
Description
Displays CM configuration settings.
Identifies the cable interface and downstream port on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On
the Cisco uBR7200 series router, slot can range from 3 to 6, and port
can be 0 or 1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The
following are the valid values:
slot = 5 to 8
•
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
Chapter 3
Cisco CMTS Show Commands
OL-1581-08
Advertisement
Table of Contents
