Table of Contents
Advertisement
hccp switch
hccp switch
To manually switch a Protect CMTS with its Working CMTS peer (or vice versa), use the hccp switch
command in privileged EXEC mode.
Syntax Description
group
member
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.1(3a)EC
12.1(7)EC1
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC2
12.2(11)BC1
12.2(11)BC3
Usage Guidelines
This command overrides any configuration you may have made on your Protect CMTS and Working
CMTS using the hccp revert and hccp reverttime commands. In addition, you can issue the hccp
switch command on either a Protect CMTS or a Working CMTS to force it to change places with its peer.
Examples
The following example shows the host Protect CMTS being configured to assume traffic responsibility
for member 2 Working CMTS in group 2:
router# hccp 2 switch 2
Cisco Broadband Cable Command Reference Guide
2-430
hccp group switch member
The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
The member number for the specified interface. Valid values are any
number from 1 to 255, inclusive.
Modification
This command was introduced for the Cisco uBR7200 series routers.
Support was added for the Cisco uBR-MC16S cable interface line card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC28C card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and
Cisco uBR-LCP-MC16S cards.
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,
and Cisco uBR-MC28C cards.
This command is automatically disabled for approximately 2 to 3 seconds
after a PRE module switches over to allow the system to stabilize before
performing another switchover.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
