Cisco SR2016T-NA Reference Manual page 396

clear cable modem lock
clear cable modem lock
To reset the lock on one or more CMs, and to reinitialize them, so that they can reregister with a valid
DOCSIS configuration file, use the clear cable modem lock command in privileged EXEC mode.
Syntax Description
mac-addr
ip-addr
cable slot/port
cable slot/subslot/port
all
oui string
Defaults
No default behavior or values
Command Modes Privileged EXEC
Command History Release
12.2(15)BC1
Usage Guidelines When you have configured the
"locks" CMs that use a DOCSIS configuration file that fails the CMTS verification check. These CMs
are allowed to come online, but with a restrictive QoS configuration that limits their service flows to
10 kbps.
Locked CMs will not be allowed to reregister with a valid DOCSIS configuration file until they have
been offline, without attempting to reregister, for at least 24 hours. You can manually clear the lock on
a CM by using the clear cable modem lock command in privileged EXEC mode.
Cisco Broadband Cable Command Reference Guide
2-384
clear cable modem {mac-addr | ip-addr | all | oui string} lock
Modification
This command was introduced.
Specifies the 48-bit hardware address (MAC address) of an individual
CM.
Specifies the IP address of an individual CM.
Identifies the a interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
Identifies a cable interface on the Cisco uBR10012 router. The
following are the valid values:
slot = 5 to 8
•
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
Resets the lock for all CMs.
Resets the lock for all CMs from a vendor that matches the specified
Organization Unique Identifier (OUI). The string parameter can be
either the three byte hexadecimal string (such as 00.00.0C) or a vendor
name that has been defined using the cable modem vendor command.
cable dynamic-secret lock
Chapter 2 Cisco CMTS Configuration Commands
command on a cable interface, the CMTS
OL-1581-08