Cisco SR2016T-NA Reference Manual page 227

Chapter 2 Cisco CMTS Configuration Commands
At the time of this document's release, the DOCSIS-QOS MIB is still in draft form and is therefore
Note
subject to change in future releases of Cisco IOS software.
The max-entry value specified by this command applies to the entire chassis for the Cisco uBR7100
series and Cisco uBR7200 series routers, but to individual line cards on the Cisco uBR10012 router.
However, the Cisco uBR10012 router still maintains only one log table for all deleted service flows.
For example, if the max-entry value is set to 10,000 on a Cisco uBR7200 series router, the service flow
log table holds a maximum of 10,000 entries for all cable line cards in the chassis. If the max-entry value
is set to 10,000 on a Cisco uBR100012 router that has four cable line cards installed, the service flow
log table holds a maximum of 40,000 entries, with each cable line card having a maximum of 10,000
entries each.
Examples
The following example shows how to enable service flow logging with a maximum of 2,000 entries in
the log, and with each entry remaining in the log for a maximum of 2 hours (7200 seconds):
Router(config)# cable sflog max-entry 2000 entry-duration 7200
The following example shows how to set the max-entry value to its default of 0 and disable service flow
logging:
Router# configure terminal
Router(config)# no cable sflog
Router(config)# exit
Router#
Related Commands Command
cable service-flow
inactivity-timeout
cable service flow
inactivity-threshold
OL-1581-08
Description
Sets the amount of time a dynamic service-flow can be present in the system
without any activity (DOCSIS 1.0 operation).
Sets the amount of time a dynamic service-flow can be present in the system
without any activity (DOCSIS 1.1 operation).
Cisco Broadband Cable Command Reference Guide
cable sflog
2-215