Cisco SR2016T-NA Reference Manual page 464

option
Table 2-22
Table 2-22 TLV Values to Enable the Cisco Cable Monitor
Type
TLV 1—Vendor ID, Suboption 8
08
TLV2—Cisco IOS Command, Suboption 131
83
The following example shows the instance keyword being used to give multiple option 43 commands.
This example uses the same commands shown in the previous three examples.
router(config-file)# option 43 instance 1 hex 08:03:00:00:0C:01:04:05:7F:9F:90
router(config-file)# option 43 instance 2 hex 08:03:00:00:0C:80:07:69:6F:73:2E:63:66:67:
0A:01:02
router(config-file)# option 43 instance 3 hex
08:03:00:00:0C:83:1D:69:70:20:68:74:74:70:20:63:61:62:6C:65:2D:6D:6F:6E:69:74:6F:72:20:61:
64:76:61:6E:63:65
router(config-file)#
The following example shows an attempt to specify two options that cannot be specified through the
DOCSIS configuration file. Option 12 is reserved for the DOCSIS registration process, and Option 9
must be specified using the
router(config-file)# option 12 ip 10.11.12.13
%Option 12 must not be specified manually
router(config-file)# option 9 ascii newsoftware.file
%Option 9 must be specified directly (not as raw option)
router(config-file)#
Related Commands Command
cable config-file
access-denied
channel-id
cpe max
download
frequency
privacy
service-class
snmp manager
timestamp
Cisco Broadband Cable Command Reference Guide
2-452
lists the two TLVs shown in this example:
Length Value
03 00:00:0C (the ID for Cisco cable equipment)
1D 69:70:20:68:74:74:70:20:63:61:62:6C:65:2D:6D:6F:6E:69:74:6F:
72:20:61:64:76:61:6E:63:65 (ASCII hexadecimal bytes for ip http
cable-monitor advance)
download
Description
Creates a DOCSIS configuration file and enters configuration file
mode.
Disables access to the network.
Specifies upstream channel ID.
Specifies CPE information.
Specifies download information for the configuration file.
Specifies downstream frequency.
Specifies privacy options for baseline privacy images.
Specifies service class definitions for the configuration file.
Specifies Simple Network Management Protocol (SNMP) options.
Enables time-stamp generation.
Chapter 2
command.
Cisco CMTS Configuration Commands
OL-1581-08