Table of Contents
Advertisement
cable ip-broadcast-echo
cable ip-broadcast-echo
To activate upstream IP broadcast echo so that the Cisco CMTS can echo broadcast packets, use the
cable ip-broadcast-echo command in cable interface or subinterface configuration mode. To disable the
upstream IP broadcast echo, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled
Command Modes
Cable interface and subinterface configuration
Command History
Release
11.3 XA
12.1(3a) EC
12.1(5)EC
Usage Guidelines
By default, broadcast IP packets that arrive on the upstream at the Cisco CMTS are not forwarded on the
downstream ports so that they would be delivered to the other CMs and CPE devices. This behavior
prevents broadcast storms in which such packets are repeatedly looped through the network.
The cable ip-broadcast-echo command changes this behavior by forwarding such packets on the
appropriate downstream ports, so that the packet is received by all CMs and CPE devices on that segment
of the network. This allows the cable network to behave more like a standard Ethernet network, and
support direct peer-to-peer communications using IP broadcasts.
This command should not be used in a typical service provider network.
Note
Examples
The following example shows how to activate IP broadcast echo in the cable interface configuration
mode:
router(config-if)# cable ip-broadcast-echo
The following example shows how to activate IP broadcast echo in the cable subinterface configuration
mode:
router(config)# interface cable 6/0.1
router(config-subif)# cable ip-broadcast-echo
Cisco Broadband Cable Command Reference Guide
2-118
cable ip-broadcast-echo
no cable ip-broadcast-echo
Modification
This command was introduced.
The subinterface support was added.
Support was added for the Cisco uBR7100 series routers.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
