Cisco SR2016T-NA Reference Manual page 601

Chapter 3 Cisco CMTS Show Commands
show cable modem qos
To display quality of service (QoS) and service flow information for a particular CM, use the show cable
modem qos command in privileged EXEC mode.
Syntax Description
ip-address
mac-address
verbose
Command Modes Privileged EXEC
Command History Release
11.3XA
Usage Guidelines This command displays the service flows currently in use by a CM. The default form of the display
shows one service flow per line, while the verbose form displays complete information for each flow.
Note Also see the information about this command's behavior in a Hot Standby Connection-to-Connection
Protocol (HCCP) configuration, see the
Protocol (HCCP) Configuration" section on page
Examples The following example shows sample output for the show cable modem qos command for a particular
CM, as identified by its MAC address:
Router# show cable modem 0010.7bb3.fcd1 qos
Sfid
3
4
Router#
The following example shows sample output for the show cable modem qos command for a particular
CM, as identified by its IP address:
Router# show cable modem 22.1.1.10 qos
Sfid
7
OL-1581-08
show cable modem {ip-address | mac-address} qos [verbose]
Displays the QoS information for the specific CM, as identified by its IP
address.
Displays the QoS information for the specific CM, as identified by its MAC
address.
(Optional) Displays detailed information for each service flow ID (SFID)
for the CM.
Modification
This command was introduced.
Dir Curr Sid Sched
State Type
US act 1 BE
DS act N/A BE
Dir Curr Sid Sched
State Type
US act 3 BE
"Operation with Hot Standby Connection-to-Connection
3-54.
Prio MaxSusRate MaxBrst
7 2000000 1522
0 4000000 1522
Prio MaxSusRate MaxBrst
0 0 3044
Cisco Broadband Cable Command Reference Guide
show cable modem qos
MinRsvRate Throughput
100000 0
0 0
MinRsvRate Throughput
0 0
3-105