Table of Contents
Advertisement
hccp ds-switch
hccp ds-switch
To specify the downstream upconverter module for a Working CMTS or Protect CMTS, use the hccp ds-
switch command in cable interface configuration mode. To negate a downstream upconverter
assignment, use the no form of this command.
This command has been deprecated in current Cisco IOS releases and has been replaced by the
Note
channel-switch
Syntax Description
group
member
make
host-ipaddr
host-module
peer-ipaddr
peer-module
1. The identification of the upconverter module is important to define when the host or peer CMTS is connected to a channel
Defaults
Upconverter specification and activation is disabled by default and must be specified before switching
can take place.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.1(3a)EC
12.1(7)EC1
12.2(4)XF1,
12.2(4)BC1
Cisco Broadband Cable Command Reference Guide
2-418
hccp group ds-switch member make host-ipaddr host-module peer-ipaddr peer-module
no hccp group ds-switch member
command.
The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
The member number within the specified group.
The maker of the specified upconverter. Currently, only the Wavecom
upconverter is supported (wavecom).
The IP address of the upconverter module
connected.
The upconverter module number to which the host CMTS is connected. This
location is expressed as a simple numeric designation.
The IP address of the upconverter module to which the peer (or remote)
CMTS is connected.
The upconverter module number
connected. This location is expressed as a simple numeric designation.
switch housing multiple modules. For example, the Wavecom MA4040D upconverter chassis offers a maximum of 10
independent frequency agile upconverters.
Modification
This command was introduced for the Cisco uBR7200 series routers.
Support was added for the Cisco uBR-MC16S cable interface line card.
This command was deprecated and replaced by the
command.
Chapter 2
Cisco CMTS Configuration Commands
1
to which the host CMTS is
1
to which the peer (or remote) CMTS is
hccp channel-switch
hccp
OL-1581-08
Advertisement
Table of Contents
