Cisco SR2016T-NA Reference Manual page 150

cable load-balance group policy ugs
Examples The following example shows how to enable the UGS policy on a load-balance group (the default
configuration), so that the Cisco CMTS can move cable modems with active UGS service flows as
needed to enforce the current dynamic load balancing policy:
Router# config terminal
Router(config)# cable load-balance group 13 policy ugs
Router(config)#
The following example shows how to configure a load-balance group so that the Cisco CMTS does not
move cable modems with active UGS service flows (default configuration):
Router# config terminal
Router(config)# no cable load-balance group 100 policy ugs
Router(config)#
Related Commands Command
cable load-balance
group (interface
configuration)
cable load-balance
exclude
cable load-balance
group (global
configuration)
cable load-balance
group interval
cable load-balance
group threshold
cable upstream load-
balance group
clear cable load-
balance
show cable load-
balance
Cisco Broadband Cable Command Reference Guide
2-138
Description
Assigns a downstream to a load-balance group.
Excludes a particular cable modem, or all cable modems from a particular
vendor, from one or more types of load-balancing operations.
Creates and configures a load-balance group.
Configures the frequency of the load-balancing policy updates.
Configures the threshold values that a load-balance group should use for
load-balancing operations.
Assigns an upstream to a load-balance group.
Clears the counters or state machine used to track load-balancing
operations.
Displays real-time statistical and operational information for load-
balancing operations.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08