Table of Contents
Advertisement
hccp reverttime
hccp reverttime
To specify the amount of time a Protect interface waits before automatically reverting back to a Working
interface following a system switchover, use the hccp reverttime command in cable interface
configuration mode on the Working CMTS. To set the revert-time back to its default value, use the no
form of this command.
Syntax Description
group
revert-time
Defaults
30 minutes
Command Modes
Interface configuration (cable interface only, on the Working CMTS)
Command History
Release
12.1(3a)EC
12.1(7)EC1
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC2
12.2(11)BC1
Usage Guidelines
Use this command to configure the revert-time on the cable interfaces on the Working CMTS so that the
Working CMTS will automatically resume normal operations and the Protect CMTS will automatically
resume normal protect operations, in case an operator forgets to manually switch the Working CMTS
back into operation after fixing the original problem.
The Working CMTS first counts down two minutes of suspend time before starting to count down the
revert-time. Any failures that occur within this two-minute suspend time are considered part of the same
failure.
Cisco Broadband Cable Command Reference Guide
2-428
hccp group reverttime revert-time
no hccp group reverttime
The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
The amount of time (in minutes) that a Protect interface waits before
automatically switching back to a Working interface following a system
switchover. The allowable range is 1 to 65,535 minutes, with a default of 30
minutes.
Modification
This command was introduced for the Cisco uBR7200 series routers.
Support was added for the Cisco uBR-MC16S cable interface line card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC28C card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and
Cisco uBR-LCP-MC16S cards.
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,
and Cisco uBR-MC28C cards.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
