Table of Contents
Advertisement
debug cable flap
When debugging is turned on, the Cisco CMTS displays the following message when a CM is added to
the flap list:
Cable modem <<mac address>> added to flap-list
When debugging is turned on, the Cisco CMTS displays the following message when a CM is removed
from the flap list:
Cable modem <<mac address>> removed from flap-list (<<number>> seconds after last flap)
When debugging is turned on, the Cisco CMTS displays the following message when it checks the flap
list for whether any CMs have aged out and should be removed from the list:
CMTS flap list aging check (interval = 120 min)
Related Commands
cable flap-list aging
cable flap-list insertion-time
cable flap-list
miss-threshold
cable flap-list power-adjust
threshold
cable flap-list size
clear cable flap-list
ping docsis
show cable flap-list
Cisco Broadband Cable Command Reference Guide
5-36
Specifies the number of days to keep a CM in the flap-list table before
aging it out of the table.
Sets the insertion time interval that determines whether a CM is
placed in the flap list.
Specifies miss threshold for recording a flap-list event.
Specifies the power-adjust threshold for recording a CM flap-list
event.
Specifies the maximum number of CMs that can be listed in the
flap-list table.
Clears all the entries in the flap-list table.
Sends a DOCSIS ping to a CM and increments the flap-list counters
as appropriate.
Displays the current contents of the flap list.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
