Cisco SR2016T-NA Reference Manual page 795

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

Commands for the Cisco uBR10012 Router

00:49:41: Downloading Microcode: file=system:pxf/ubr10k-1-ucode.122.1.0, version=122.1.0,

description=Release Software created Wed 17-Jul-02 16:58

<<list of interfaces going down or coming up>>

00:49:42: !!pxf clients started, forwarding code operational!!

The following example shows a typical list of devices that you can use when loading microcode for the

PXF processors. This list might vary, depending on whether a standby PRE1 module is installed and

depending on the version of Cisco IOS software being used.

Router# microcode reload pxf ?

sec-bootflash:

The following example shows how to reload the microcode on the PXF processors on the PRE1 module,

using a specific image that is stored in the Flash memory:

Router# microcode reload pxf flash:pxf/ubr10k-1-ucode.122.1.0.4

Reload microcode? [confirm] yes

3d00h: Downloading Microcode: file=flash:pxf/ubr10k-1-ucode.122.1.0.4, version=122.1.0.4,

description=Release Software created Thu 27-Jun-02 16:05

<<list of interfaces going down or coming up>>

3d00h: !!pxf clients started, forwarding code operational!!

Related Commands

hw-module reset

show pxf microcode

location of microcode

Resets a particular PRE1 module or a particular line card.

Reloads the microcode software images on one or all line cards that support

downloadable microcode.

Displays display identifying information for the microcode being used on

the PXF processors.

Cisco Broadband Cable Command Reference Guide

microcode reload

Broadband cable