Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
cable sync-interval
To specify the interval between successive sync message transmissions from the Cisco CMTS, use the
cable sync-interval command in cable interface configuration mode. To return the sync message interval
to its default value, use the no form of this command.
Syntax Description
msec
Defaults
10 ms
Command Modes
Interface configuration (cable interface only)
Command History
Release
11.3 NA
Usage Guidelines
To verify whether or not a sync message interval has been configured, enter the show running-config
command and look for the cable interface configuration information. If a sync message interval has been
configured, it appears in this output. If the sync message interval has been deactivated or reset to its
default value, no sync interval command line appears in the output.
Examples
The following example shows how to specify the interval for the sync message transmissions to 100 ms:
Router (config-if)# cable sync-interval 100
OL-1581-08
cable sync-interval msec
no cable sync-interval
Modification
This command was introduced.
Specifies the interval in milliseconds (ms) between successive sync
message transmissions from the Cisco CMTS. Valid values are from
1 to 200 ms. Default value is 10 ms.
Cisco Broadband Cable Command Reference Guide
cable sync-interval
2-249
Advertisement
Table of Contents
