Table of Contents
Advertisement
Chapter 3
Cisco CMTS Show Commands
In Cisco IOS Release 12.2(11)BC3 and later releases, the Cisco CMTS automatically maps the non-
Note
default DOCSIS 1.0 QoS profiles to profile numbers starting at 128, to facilitate their use in DOCSIS
1.1 networks.
The following example shows typical output for the verbose form of the show interface cable qos
paramset command:
Router# show interface c6/0 qos paramset 1 verbose
Index:
Name:
Direction:
Traffic Priority:
Maximum Sustained Rate:
Max Burst:
Minimum Reserved Rate:
Minimum Packet Size
Maximum Concatenated Burst:
Scheduling Type:
Request/Transmission Policy:
Nominal Polling Interval:
Tolerated Poll Jitter:
Unsolicited Grant Size:
Nominal Grant Interval:
Tolerated Grant Jitter:
Grants per Interval:
IP ToS Overwrite [AND-mask,OR-mask]:
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show commands using the exec prompt timestamp command in line configuration mode.
Related Commands
show cable qos
permission
show cable modem qos
show cable qos profile
OL-1581-08
1
Upstream
0
64000 bits/sec
0 bytes
0 bits/sec
0 bytes
1522
Best Effort
0x0
0
0
0 bytes
0 usecs
0 usecs
0
0x0,0x0
Displays the status of permissions for changing QoS tables.
Displays quality of service (QoS) and service flow information for a
particular CM.
Displays the QoS profiles that have been defined.
Cisco Broadband Cable Command Reference Guide
show interface cable qos paramset
3-227
Advertisement
Table of Contents
