Table of Contents
Advertisement
hw-module slot srp
hw-module slot srp
To configure a line card slot for Spatial Reuse Protocol (SRP) operation, use the hw-module slot srp
command in privileged EXEC mode. To remove the configuration for a line card slot, use the no form
of this command.
Syntax Description
slot slot-number
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(11)BC3
Usage Guidelines
You must first use the hw-module slot srp command to preconfigure a line card slot for SRP operation
of a pair of Cisco uBR10012 OC-48 DPT cards before you can configure the cards with any further
commands. You must also use the card 1oc48dpt/pos-1 command to configure each card slot for the
proper card type.
The Cisco uBR10012 OC-48 DPT line cards support SRP operation only when installed in adjacent odd-
Tip
and even-numbered slots (such as slots 1 and 2 or 3 and 4). You need to use the hw-module slot srp
command only for the lower-numbered (odd-numbered) slot to preconfigure both slots of the SRP pair.
If you have previously used the hw-module slot pos command to configure line card slots for Packet
Note
over SONET (POS) operation, you must first cancel that configuration using the no hw-module slot pos
command before you can configure the slots for POS operation using the hw-module slot srp command.
Examples
The following example shows the Cisco uBR10012 OC-48 DPT line cards in slots 1 and 2 being
configured for POS operation:
Router# hw-module slot 1 srp
Router# card 1/0 1oc48dpt/pos-1
Router# card 2/0 1oc48dpt/pos-1
Cisco Broadband Cable Command Reference Guide
4-26
hw-module slot slot-number srp
no hw-module slot slot-number srp
Resets the line cards that are physically present in the specified slot-number
(valid range is 1 to 8).
Modification
This command was introduced for the Cisco uBR10012 OC-48 Dynamic
Packet Transport (DPT) Interface Module for the Cisco uBR10012 router.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
