Cisco SR2016T-NA Reference Manual page 372

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

To preprovision a slot in the Cisco uBR10012 universal broadband router for a particular interface card,

so that you can configure the interface without it being physically present in the slot, use the card

command in global configuration mode. To remove the preprovisioning for a card, so that the physical

slot reports being empty, use the no form of this command.

Syntax Description

The list of supported card types depends on the Cisco IOS software release being used. See the release

notes for your release for the complete list of cards that are supported.

An empty card slot is not preprovisioned and cannot be configured or displayed.

Command Modes

Global configuration

Command History

Cisco Broadband Cable Command Reference Guide

card slot/port card-type

no card slot/port

Modification

This command was introduced for the Cisco uBR10012 router, and for the

following line cards:

Cisco uBR-LCP-MC28C cable interface line card

Cisco uBR-LCP-MC28C-BNC cable interface line card

Cisco uBR10-1GE Gigabit Ethernet (GigE) uplink line card

Cisco uBR10-1OC12/P-SMI OC-12 POS uplink line card

Support was added for the Cisco uBR-LCP-MC16C and Cisco uBR-LCP-

MC16E cable interface line cards.

Support was added for the Cisco uBR10-SRP-OC12SML DPT WAN uplink

Support was added for the Cisco LCP2 line card processor, and all of its

combinations with the supported cable interface line cards.

Support was added for the Cisco uBR10012 OC-48 DPT/POS Interface

Module uplink line card and Cisco uBR-MC5X20S cable interface line card.

Identifies the Cisco CMTS chassis slot number for the card. The valid

range is 1 to 8.

Identifies the Cisco CMTS port number for the card. The valid values

are 0 or 1, depending on the slot number.

Specifies the type of card that should be used to preprovision the slot.

for a list of the supported cards.

Cisco CMTS Configuration Commands

Broadband cable