Table of Contents
Advertisement
debug checkpoint
debug checkpoint
To enable debugging of the Checkpointing Facility (CF) subsystem on the Cisco uBR10012 router, use
the debug checkpoint command in privileged EXEC mode. To disable debugging output, use the no
form of the command.
Syntax Description
all
errors
messages
temporary
timers
Command Modes
Privileged EXEC
Command History
Release
12.2(11)BC3
Usage Guidelines
The debug checkpoint command enables debugging of the Checkpoint Facility (CF) subsystem, which
passes messages from the Active processor to the Standby processor. It also handles sequencing and
throttling, as needed, during redundancy operations.
Examples
The following example shows how to enable debugging messages for the CF subsystem:
Router# debug checkpoint
Router#
Related Commands
Command
debug cable interface
debug cable
mac-address
Cisco Broadband Cable Command Reference Guide
5-90
debug checkpoint [all | errors | messages | temporary | timers]
no debug checkpoint [all | errors | messages | temporary | timers]
(Optional) Enables all checkpoint debugging types.
(Optional) Enables debugging of any checkpoint errors that occur.
(Optional) Enables debugging for the messages that are sent during
checkpoint operations.
(Optional) Enables basic checkpoint debugging (default).
(Optional) Enables debugging of the checkpoint timers.
Description
Enables debugging on a specific cable interface.
Enables debugging for a specific CM, as identified by its hardware (MAC)
address.
Modification
This command was introduced for the Cisco uBR10012 universal
broadband router.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
