Cisco SR2016T-NA Reference Manual page 378

clear cable dsg
clear cable dsg
To reset counters related to DOCSIS Set-Top Gateway (DSG) tunnels, use the clear cable dsg command
in privileged EXEC mode.
Syntax Description
This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History Release
12.2(15)BC2
Usage Guidelines DSG operation is disabled using the no cable dsg command, but this does not clear out the DSG-related
counter ("mapping entry is used"), so that you can retain its value in case you intend to restart DSG
operations again. If, however, you want to reset those counters to zero, use the clear cable dsg command.
This command resets the "mapping entry is used" counters for all DSG tunnels and interfaces on the
Note
router.
Examples The following example shows how to clear the DSG counters for all cable interfaces on the router, and
shows an example of the show cable dsg command showing the counters after they have been cleared.
Router# show cable dsg stats
DSG statistics information
DSG keepalive is set
Vendor: DDD, Tunnel count: 1
Vendor: BBB, Tunnel count: 2
Vendor name is DDD, tunnel MAC is 0001.0002.0003
Group address is 226.2.2.2, source address is *
Interface is Cable5/1,
Router# clear cable dsg
Router# show cable dsg stats
DSG statistics information
Vendor: DDD, Tunnel count: 1
Vendor: BBB, Tunnel count: 2
Cisco Broadband Cable Command Reference Guide
2-366
clear cable dsg
Modification
This command was introduced for the Cisco uBR7100 series and
Cisco uBR7246VXR routers.
Received 5968 packets,
Dropped 679 packets, last second rate 16878 bits/sec
mapping entry is used 2
forwarded 5289 packets
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08