Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
clear hccp counters
To reset the counters for one or all Hot Standby Connection-to-Connection Protocol (HCCP) groups, use
the clear hccp counters command in privileged EXEC mode.
Syntax Description
group
all
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Release
12.1(3a)EC
12.1(7)EC1
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC2
12.2(11)BC1
Usage Guidelines
This command clears the counter that are displayed by the
commands. You can clear the counters for a single HCCP group, or all HCCP groups.
Examples
The following example shows the counters for group 1 being reset to 0:
Router# clear hccp 1 counters
Router#
The following example shows the counters for all groups being reset to 0:
Router# clear hccp all counters
Router#
OL-1581-08
clear hccp [group | all] counters
Clears the counters for the specified group number. The valid range is 1 to
255.
Clears the counters for all HCCP groups.
Modification
This command was introduced for the Cisco uBR7200 series routers.
Support was added for the Cisco uBR-MC16S cable interface line card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC28C card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and
Cisco uBR-LCP-MC16S cards.
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,
and Cisco uBR-MC28C cards.
show hccp
and
show hccp interface
Cisco Broadband Cable Command Reference Guide
clear hccp counters
2-393
Advertisement
Table of Contents
