Table of Contents
Advertisement
Chapter 4
Commands for the Cisco uBR10012 Router
Router(config-r)# associate slot 1 2
Router(config-r)#
The following example does the same as above, but the router automatically assumes that the card in
slot 2 is the redundant card:
Router# config t
Router(config)# redundancy
Router(config-r)# associate slot 1
Router(config-r)#
The following example removes the association for redundant line cards:
Router# config t
Router(config)# redundancy
Router(config-r)# no associate slot 1
Router(config-r)#
The following example shows the error message that is displayed when you attempt to associate an even
slot as the working slot and an odd slot as the backup slot:
Router# config t
Router(config)# redundancy
Router(config-r)# associate slot 2 3
Slot redundancy must be configured on adjacent odd/even slots.
Router(config-r)#
The following example shows the error messages that are displayed when you attempt to associate line
cards that do not support APS redundancy:
Router(config-r)# associate slot 5 6
Associate slot command NOT accepted for chassis config.
One or more slots are occupied by linecards that don't support redundancy.
Router(config-r)#
The following example shows the error messages that are displayed when you attempt to associate a slot
that is either empty or that does not contain a supported line card:
Router(config-r)# associate slot 1 2
Associate slot command NOT accepted for chassis config.
One or more slots are occupied by half height Linecards.
Router(config-r)#
Related Commands
Command
auto-sync
main-cpu
redundancy
OL-1581-08
Description
Configures which files are synchronized between the active and standby
PRE1 modules.
Enters main CPU redundancy configuration mode.
Enters redundancy configuration mode.
Cisco Broadband Cable Command Reference Guide
associate
4-7
Advertisement
Table of Contents
