Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
snmp-server enable traps cable
To enable the sending of Simple Network Management Protocol (SNMP) traps for cable-related events,
use the snmp-server enable traps cable command in global configuration mode. To disable the sending
of traps, use the no form of this command.
Syntax Description
cm-chover
cm-onoff
cm-remote-query
dmic-lock
enfrule-violation
hccp-failover
hopping
usage
Defaults
No SNMP traps for cable-related events are enabled. You can specify one type of trap or any combination
of traps. When the snmp-server enable traps cable command is given without any options, all cable-
related traps are enabled.
Command Modes
Global configuration
Command History
Release
12.0(5)T
12.0(7)XR2, 12.1(1)T
12.1(2)EC1
12.1(7)CX1
OL-1581-08
snmp-server enable traps cable [cm-chover] [cm-onoff] [cm-remote-query] [dmic-lock]
[enfrule-violation] [hccp-failover] [hopping] [usage]
no snmp-server enable traps cable [cm-chover] [cm-onoff] [cm-remote-query] [dmic-lock]
[enfrule-violation] [hccp-failover] [hopping] [usage]
Enables traps that are sent upon completion of CMTS channel override
operations, as defined in CISCO-DOCS-EXT-MIB.
Enables traps for CM online/offline status changes, as defined in
DOCS-EXT-MIB.
Enables traps that are sent when the remote polling of CMs has been
completed, as defined in CISCO-DOCS-REMOTE-QUERY-MIB.
Enables traps that are sent when a cable modem fails the dynamic shared-
secret security checks, as defined in CISCO-DOCS-EXT-MIB.
Enables traps that are sent when a user violates their quality of service (QoS)
profile, as defined in the CISCO-CABLE-QOS-MONITOR-MIB.
Enables traps for Hot Standby Connection-to-Connection Protocol (HCCP)
redundancy switchover events, as defined in
AVAILABILITY-MIB.
Enables traps for spectrum hopping events, as defined in
SPECTRUM-MIB.
Enables traps for usage-based billing, as configured with the cable usage
commands and defined in CISCO-CABLE-BILLING-MIB.
Modification
This command, with the cm-chover and cm-onoff options, was added.
The cm-remote-query option, along with the
QUERY-MIB
This command was supported on the 12.1 EC train.
The hopping and cmts-event options were introduced.
MIB, was introduced.
Cisco Broadband Cable Command Reference Guide
snmp-server enable traps cable
CISCO-
CISCO-CABLE-
CISCO-CABLE-
CISCO-DOCS-REMOTE-
2-477
Advertisement
Table of Contents
