Cisco SR2016T-NA Reference Manual page 961

Chapter 5 Cisco CMTS Debugging Commands
debug hccp docsis-recovery
To display debug messages about the recovery of CMs during HCCP N+1 (1:n) redundancy operations,
use the debug hccp docsis-recovery command in privileged EXEC mode. To disable the debug message
output, use the no form of this command.
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History Release
12.2(15)BC
Usage Guidelines
The debug hccp docsis-recovery command displays debugging messages about the recovery of CMs
during N+1 (1:n) HCCP operations.
Note You must use the
hccp docsis-recovery command will generate any debug output.
Examples The following example shows typical output for the debug hccp docsis-recovery command:
Router# debug hccp events
Router# debug hccp docsis-recovery
HCCP DOCSIS Recovery ACTION/EVENT messages debugging is on
HCCP 1 1 Working: Built 4 prio 3 CMs [tot 23]
Related Commands Command
debug hccp
authentication
debug hccp events
debug hccp inter-db
debug hccp plane
debug hccp sync
debug hccp timing
OL-1581-08
debug hccp docsis-recovery
no debug hccp docsis-recovery
Modification
This command was introduced.
debug hccp events
Description
Displays authentication debug messages for HCCP groups.
Displays debug messages for all HCCP group interaction.
Displays debug messages for the inter-database events during HCCP
operations.
Displays debug messages for HCCP-related messages sent between the
router's control plane and data backplane.
Displays debug messages for HCCP synchronization messages.
Displays debug messages for the timing of HCCP events.
command to activate HCCP event debugging before the debug
Cisco Broadband Cable Command Reference Guide
debug hccp docsis-recovery
5-101