Cisco SR2016T-NA Reference Manual page 981

Chapter 5 Cisco CMTS Debugging Commands
debug packetcable gate
To display general debugging messages for specific PacketCable gate events and messages, use the
debug packetcable gate command in privileged EXEC mode. To turn off Packetcable debugging, use
the no form of this command.
Syntax Description
commit
control
coordination
database
docsis-mapping
events
process
detail
Command Modes
Privileged EXEC
Command History Release
12.2(8)BC2
12.2(15)BC1
12.2(15)BC2
OL-1581-08
debug packetcable gate {commit | control | coordination | database | docsis-mapping |
events [process] } [detail]
no debug packetcable gate {commit | control | coordination | database | docsis-mapping |
events [process] } [detail]
Displays debugging messages for the commit events on each gate.
Displays debugging messages for gate control events (allocation, set, and
delete).
Displays debugging messages for gate coordination events (gate close and
open) (not supported in Release 12.2(15)BC1 and later releases).
Displays debugging messages for all updates to the gate database, including
gate creation and deletion, state transitions, and structure updates.
Displays debugging messages for the mapping between PacketCable and
Data-over-Cable System Interface Specification (DOCSIS) parameters.
Displays debugging messages for the event messages that are sent during a
voice call.
(Optional) Displays non-subscriber-related process event messages
(available only when using the events option).
Displays additional debug messages for specific events, such as the contents
of a PacketCable headers and messages.
Note
Modification
This command was introduced for the Cisco uBR7200 series universal
broadband router.
The coordination and detail options were removed, and the process option
was added. Support was also added for the Cisco uBR10012 router. In
addition, most options no longer display any output until PacketCable
debugging has been enabled for one or more IP addresses, using the
packetcable subscriber
The hccp option was added.
Release 12.2(15)BC1 removed this option and replaced it with the
verbose option of the debug packetcable subscriber
command.
Cisco Broadband Cable Command Reference Guide
debug packetcable gate
command.
debug
5-121