Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Usage Guidelines
It is necessary to configure the downstream upconverter module for all Protect CMTS and Working
CMTS systems. If you do not specify the downstream upconverter module for all Protect CMTS and
Working CMTS systems, you cannot switch between a Protect CMTS and Working CMTS.
Examples
The following excerpt from a configuration file specifies module 2 on a Wavecom upconverter at IP
address 1.1.11.3 as the host switch module connected to Working CMTS 1 and module 1 on the same
Wavecom upconverter (with the same IP address location) as the peer or remote switch module
connected to the Protect CMTS:
hccp 1 working 1
hccp ds-switch 1 wavecom 1.1.11.3 2 1.1.11.3 1
Related Commands
Command
hccp channel-switch
hccp protect
hccp working
show hccp
show hccp interface
OL-1581-08
Description
(replaces the hccp ds-switch command).
Allows you to configure a Cisco CMTS to be a Protect CMTS for a specified
Working CMTS in a 1+1 redundancy environment.
Allows you to designate a Cisco CMTS to be a Working CMTS in a 1+1
redundancy environment.
Displays information for all cable interfaces on which one or more HCCP
groups and authentication modes have been configured.
Displays group information for a specific cable interface on which one or
more groups and authentication modes have been configured.
Cisco Broadband Cable Command Reference Guide
hccp ds-switch
2-419
Advertisement
Table of Contents
