Table of Contents
Advertisement
debug cable load-balance
debug cable load-balance
To display debugging messages for load-balancing operations on the router, use the debug cable
load-balance command in privileged EXEC mode. To stop the display of debugging messages, use the
no form of this command.
Syntax Description
error
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
The debug cable load-balance command displays debugging output for when cable modems come
online those cable interfaces that are part of a load balance group. It also displays debugging messages
when cable modems are moved to achieve balanced loads on those cable interfaces.
Because this command can produce a large volume of debug information, Cisco recommends that you
Tip
limit debugging output to a particular interface or MAC address, using the debug cable interface and
debug cable mac-address commands, respectively.
Examples
The following example shows typical output for the debug cable load-balance command for a particular
cable interface:
Router# debug cable interface c3/0
Router# debug cable load-balance
CMTS load balancing debugging is on
*Feb 13 13:39:21.594 PDT: lb: Removing Modem entry 0050.7318.e615: at target (upstream)
*Feb 13 13:39:50.754 PDT: lb: US request from Cable3/0/U0[0050.7366.1f7b]: target U3
[enforce], 0 retries
*Feb 13 12:53.010 PDT: lb: Moving Modem 0050.7366.218b from Cable3/0/U0 to U2
Cisco Broadband Cable Command Reference Guide
5-46
debug cable load-balance [error]
no debug cable load-balance [error]
(Optional) Displays debugging messages about errors that might occur
during load-balancing operations about the actual number of CMs that are
active on a channel.
Modification
This command was introduced for the Cisco uBR7246VXR and
Cisco uBR10012 routers.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
