Cisco SR2016T-NA Reference Manual page 794

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

microcode reload

To reload the microcode software images on one or all line cards that support downloadable microcode,

use the microcode reload command in privileged EXEC mode.

Syntax Description

device:[filename]

For microcode reload pxf, defaults to loading the microcode image that was originally loaded when the

Cisco IOS software image was loaded.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

By default, the Cisco uBR10012 router automatically loads all required microcode on to the PXF

processors and other line cards when it loads the Cisco IOS software image. Also, the PRE1 module

automatically reloads the microcode on a card when certain faults occur, allowing the card to recover

from the fault.

You can reload the microcode on the PRE1 module or on all line cards that support downloadable

microcode by using the microcode reload command. Typically, this is not needed and should be done

only upon the advice of Cisco TAC or field service engineers.

You can also reload the microcode on the PXF processors or on all cards using the

in global configuration mode.

The following example shows how to reload the microcode on all PRE processors and line cards that

support downloadable microcode:

Router# microcode reload all

Reload microcode? [confirm] yes

Cisco Broadband Cable Command Reference Guide

microcode reload {all | pxf [device:[filename]]}

Reloads the microcode for all Performance Routing Engine (PRE1)

modules and other line cards that support downloadable microcode

software images.

Reloads the microcode for the Parallel eXpress Forwarding (PXF)

processors on the PRE1 module.

(Optional) Loads the PXF processors with the microcode software image

that has the specific filename on the specific device. If no filename is

specified, the first image found on the device is loaded by default.

Modification

This command was introduced for the Cisco uBR10012 router.

Commands for the Cisco uBR10012 Router

Broadband cable