Table of Contents
Advertisement
show controllers clock-reference
PEMA Voltage Monitor High Time Reg
PEMA Voltage Monitor Total Time Reg
PEMA Current Monitor High Time Reg
PEMA Current Monitor Total Time Reg
PEMB Voltage Monitor High Time Reg
PEMB Voltage Monitor Total Time Reg
PEMB Current Monitor High Time Reg
PEMB Current Monitor Total Time Reg
LIU0 Read Write Reg
LIU1 Read Write Reg
LCD Control Reg RS0
LCD Control Reg RS1
General Purpose Control Reg 0
General Purpose Control Reg 1
General Purpose Control Reg 2
LC Power off Status Reg
Sec Clock Control Reg
Sec Clock Status Reg
Push Button Input Reg
LC Presence Input Reg
Compare Errors rcvd from 2/1: 0
Parity Errors rcvd from 2/1 : 0
PEM A Power = 0w, PEM B Power = 343w
Router#
The
show controllers clock-reference
Note
router because there could be a slight delay at system startup before the TCC+ cards synchronize with
each other. These initial compare errors can be ignored and cleared with the
command.
Most of the information shown by the show controllers clock-reference command is in the form of a
hexadecimal bitfield that is not meaningful for normal operations, but the following fields can be useful
in troubleshooting problems with the TCC+ and cable interface line cards:
UCPC Bus Control Status Reg—Displays the status of both TCC+ cards and whether the LCD
•
Display Panel is present.
Line Card Presence Status Reg—Provides a software view of whether a cable interface line card is
•
physically present in the Cisco uBR10012 chassis.
LC Presence Input Reg—Provides a hardware view of whether a cable interface line card is
•
physically present in the Cisco uBR10012 chassis.
LC Power off Status Reg—Indicates whether a cable interface line card slot has been powered off
•
using the
Table 3-46
Cisco Broadband Cable Command Reference Guide
3-182
cable power
command.
shows how to interpret these fields.
: 0x0
: 0x0
: 0x0
: 0x0
: 0x66
: 0xCD
: 0x1C
: 0x34
: 0x30
: 0x11
: 0x66
: 0x20
: 0x0
: 0x1
: 0x43
: 0x0
: 0x80
: 0x1
: 0x0
: 0x21
command might display compare errors on the Cisco uBR10012
Chapter 3
Cisco CMTS Show Commands
cable clock clear-counters
OL-1581-08
Advertisement
Table of Contents
