Cisco SR2016T-NA Reference Manual page 813

Chapter 4 Commands for the Cisco uBR10012 Router
show pxf cable
To display information about the multicast echo, packet intercept, or source-verify features for one or all
cable interfaces, use the show pxf cable command in user EXEC or privileged EXEC mode.
Syntax Description
feature-table [cx/y/z]
maptable cx/y/z [sid]
multicast-echo ds-group Displays the cable interfaces that are associated with each downstream
multicast-echo
mcast-addr
source-verify
[ip-address]
Defaults No default behavior or values.
Command Modes
User EXEC, Privileged EXEC
Command History Release
12.2(11)CY, 12.2(11)BC2 This command was introduced as show hardware pxf cable for the
12.2(15)BC2
Usage Guidelines
The show pxf cable command displays information about whether multicast echo and packet intercept
are enabled on the cable interfaces. It can also be used to display the service flow ID (SFID) used for
each multicast address that is being processed by the router.
OL-1581-08
show pxf cable {feature-table [cx/y/z] | maptable cx/y/z [sid] |
multicast-echo ds-group | multicast-echo mcast-addr | source-verify [ip address]}
Displays the multicast echo and packet intercept status on the PXF
processor. If given without any options, displays the status for all cable
interfaces and subinterfaces. If given with an optional cable interface,
displays the status for that particular interface.
Displays memory and service ID (SID) information for a particular cable
interface. If the optional sid parameter is specified, displays information
for that particular SID.
group, where each downstream group is a unique DOCSIS MAC domain.
(Interfaces that are bundled together are considered one MAC domain.)
Displays the service flow ID (SFID) information for all multicast addresses
that hash to the same index as the specified multicast IP address.
Displays the interface and SFID mapping tables that are maintained by the
source-verify feature. If the optional ip-address parameter is specified,
displays information only for that particular IP address.
Note
Modification
Cisco uBR10012 router.
This command was renamed from show hardware pxf cable to show pxf
cable.
The source-verify option is not supported on the PRE-2 module.
Instead, use the show pxf cpu cef verbose
primary SID information on the PRE-2 module.
Cisco Broadband Cable Command Reference Guide
show pxf cable
command to display the
4-53