Table of Contents
Advertisement
Chapter 4
Commands for the Cisco uBR10012 Router
Examples
The following example shows the standby PRE1 module being reset:
Router# hw-module sec-cpu reset
Router#
The following example shows the active PRE1 module being reset and kept in the reset state (which will
trigger a switchover to the standby PRE1 module):
Router# hw-module main-cpu reset hold
Router#
The following example shows the PRE1 module in PRE slot B being reset:
Router# hw-module pre B reset
Router#
The hw-module pre B reset command resets the PRE1 module that is physically present in slot B,
Note
regardless of whether the module is the active or standby PRE1 module.
The following example shows how to reset the cable interface line card in slot 5/1:
Router# hw-module subslot 5/1 reset
Router#
Related Commands
Command
hw-module shutdown
microcode
microcode reload
redundancy
force-failover
main-cpu
OL-1581-08
Description
Shuts down a PRE1 module or line card.
Reloads the microcode software images on one or all line cards that support
downloadable microcode.
Reloads the microcode software images on one or all line cards that support
downloadable microcode.
Forces a manual switchover between the active and standby PRE1 modules.
Cisco Broadband Cable Command Reference Guide
hw-module reset
4-21
Advertisement
Table of Contents
