Table of Contents
Advertisement
cable telco-return spd factory-default
cable telco-return spd factory-default
To indicate the service provider descriptor (SPD) that the telco-return CM uses during the initialization
process, use the cable telco-return spd factory-default command in cable interface configuration
mode. To restore the default value, use the no form of this command.
Syntax Description
spd-number
Defaults
The Factory Default Flag in the SPD is set to 0, which means that this SPD is not used for the
initialization process.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the Factory Default parameter in the specified SPD in Telephony Channel Descriptor
(TCD) messages. This determines the set of telephony attributes, as defined by the SPD, that are used
for the initialization process when the CM is powered on or is reset to its factory default.
Note
This command is available only in images that support telco-return. These images have a "t" as part of
the image name.
Examples
The following example shows how to set the telco-return CM to use SPD 2 during the initialization
procedure:
router(config-if)# cable telco-return spd 2 factory-default
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
Cisco Broadband Cable Command Reference Guide
2-262
cable telco-return spd spd-number factory-default
no cable telco-return spd spd-number factory-default
Service provider descriptor (SPD) that contains the set of telephony
attributes used by the CM during initialization. Valid range is 1
through 5.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
