Table of Contents
Advertisement
cable submgmt default
Router# configure terminal
Router(config)# no cable submgmt default active
Router(config)# no cable submgmt default learnable
Router(config)# cable submgmt default max-cpe 1
Router(config)#
The following commands specify that the CMTS defaults to assigning three filter groups to each CM that
registers. Unless the CM indicates otherwise at registration time, downstream and upstream traffic for
the CPE devices behind the CM is filtered according to the rules for filter groups 20 and 21, respectively.
Filter group 1 is applied to the downstream traffic addressed to the CM. Upstream traffic sent by the CM,
however, is not filtered.
Router# configure terminal
Router(config)# cable submgmt default filter-group cpe downstream 20
Router(config)# cable submgmt default filter-group cpe upstream 21
Router(config)# cable submgmt default filter-group cm downstream 1
Router(config)# cable submgmt default filter-group cm upstream 0
Router(config)#
The above example assumes that filter groups 1, 20, and 21 have already been created on the CMTS using
Note
the appropriate SNMP commands.
Related Commands
For additional information about configuring Static CPE Override on the Cisco CMTS, refer to the
following document on Cisco.com:
•
Cisco Broadband Cable Command Reference Guide
2-248
Cisco CMTS Static CPE Override
http://www.cisco.com/en/US/products/hw/cable/ps2217/prod_troubleshooting_guide09186a00802
84e08.html
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
