Table of Contents
Advertisement
Chapter 5
Cisco CMTS Debugging Commands
debug cable startalloc
To debug channel allocations on the HFC network, use the debug cable startalloc command in
privileged EXEC mode. To disable debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Release
11.3NA
Usage Guidelines
This command activates debugging of the channel allocations on the HFC network. When this command
is activated, any messages generated when channels are allocated to CMs on the HFC network are
displayed on the Cisco CMTS console.
This command should be used for development testing only, not in production setting.
Caution
Examples
The following shows sample output from the debug cable startalloc command:
Router# debug cable startalloc
Router#
00:53:27: Cable3/U0 MAP startalloc adjusted by 1 mslots
00:53:27: Cable4/U0 MAP startalloc adjusted by 3 mslots
00:53:27: Cable3/U0 MAP startalloc adjusted by 5 mslots
00:53:27: Cable4/U0 MAP startalloc adjusted by 4 mslots
00:53:28: Cable3/U0 MAP startalloc adjusted by 4 mslots
00:53:28: Cable4/U0 MAP startalloc adjusted by 5 mslots
OL-1581-08
debug cable startalloc
no debug cable startalloc
Modification
This command was introduced.
Cisco Broadband Cable Command Reference Guide
debug cable startalloc
5-73
Advertisement
Table of Contents
