Table of Contents
Advertisement
Cisco CMTS Configuration Commands
This section describes the cable-specific commands that configure the Cisco Cable Modem Termination
System (CMTS) universal broadband routers. Refer to the following sections for more information:
•
•
This section documents only cable-specific commands. For non-cable-specific commands, see the
Tip
command reference documentation for
Documentation CD-ROM. For information about debugging commands for the Cisco CMTS routers, see
Chapter 5, "Cisco CMTS Debugging Commands."
Supported Platforms and Cisco IOS Releases
The Cable CMTS commands operate on the following Cisco CMTS platforms:
•
•
•
Table 2-1
Not all Cisco IOS releases support all Cisco CMTS platforms. See the release notes for each Cisco IOS
Note
release for details on which platforms are supported.
OL-1581-08
Supported Platforms and Cisco IOS Releases, page
Cisco IOS releases that support the commands listed in this section.
CMTS Configuration Commands, page
that are used to configure and maintain the Cisco CMTS features. (For cable-specific show
commands, see
Chapter 3, "Cisco CMTS Show
Cisco uBR7100 series universal broadband routers (the Cisco uBR7111, the Cisco uBR7111E, the
Cisco uBR7114, and the Cisco uBR7114E)
Cisco uBR7200 series universal broadband routers (the Cisco uBR7223, the Cisco uBR7246, and
the Cisco uBR7246 VXR)
Cisco uBR10012 universal broadband routers
shows the minimum supported Cisco IOS releases documented at time of this publication.
C H A P T E R
2-1—Describes the Cisco CMTS platforms and
2-3—Describes the cable-specific configuration commands
Commands.")
Cisco IOS Release
12.2, available on
Cisco Broadband Cable Command Reference Guide
2
Cisco.com
and the
2-1
Advertisement
Table of Contents
