Table of Contents
Advertisement
Chapter 5
Cisco CMTS Debugging Commands
debug cr10k-rp
(Cable 7/0/0:2) Frequency request (20000000 - 23200000) from group 22 approved
(Cable 7/0/0:3) Frequency request (20000000 - 21600000) from group 22 approved
(Cable 7/0/0:3) Release frequency (20800000, 1600000) from group 22
(Cable 7/0/0:4) Release frequency (20800000, 1600000) from group 22
(Cable 7/0/0:4) Frequency request (20000000 - 20400000) from group 22 approved
(Cable 7/0/0:5) Frequency request (20000000 - 21600000) from group 22 approved
(Cable 7/0/0:5) Release frequency (20800000, 1600000) from group 22
(Cable 7/0/0:5) Frequency request (20000000 - 20200000) from group 22 approved
(Cable 7/0/0:6) Frequency request (20000000 - 21600000) from group 22 approved
Release frequency request sent to slot 7 subslot 0
(Cable 7/0/0:6) Frequency request (21400000 - 21800000) from group %d rejected because of
overlapping band
The following lists the typical messages that are displayed by the ha-all option.
PRE Redundancy: failed to get RF buf to send msg to peer
PRE Redundancy: failed to send RF buf to peer
PRE REDUNDANCY: bulk sync in progress
PRE REDUNDANCY: Got RF message when not in Active state.
RP DS SRV FLOW packet sanity check... ok.
Failed to find DS SF with sfid 321
Deleting an old inter_rp_ds_srv_flow
Adding a new inter_rp_ds_srv_flow
Updating an inter_rp_ds_srv_flow
Processing inter_rp_ds_srv_flow
cr10k_rp_ha_parse_sync: Received Packet of 122 len
cr10k_rp_ha_parse_sync:Received
Synching cm instance
CR10K HA:
Standby recv chkpt msg
PRE REDUNDANCY: NO Resources
PRE REDUNDANCY: RF_PROG_STANDBY_BULK received
PRE REDUNDANCY:This is standby from boot
PRE REDUNDANCY: RF_PROG_ACTIVE_FAST received
The following example shows the typical messages for the ha-timing option. These messages show the
total time it takes to synchronize all of the cable modems on a cable interface after a switchover, as well
as the total time it takes for all cable modems to recover and come online. These messages also show the
total time it took the HCCP and DOCSIS protocol subsystems to synchronize after a switchover.
Router# debug cable interface c6/1/0
Router# debug cr10k-rp ha-timing
CR10K RP debug High Availability timing
PRE_HA: c6/1/0 Total modems 234 bulk sync'ed in 531 msec
(delay: 20 msec; CM's per loop:10)
PRE_HA: c6/1/0 Total modems (234) recovered in 1124 msec
PRE_HA: Completed hccp bulksync in 335 msecs
PRE_HA: Completed docsis bulksync in 751 msecs
The following example shows the typical messages for the ha-msg option. These messages show the
total time it takes to synchronize all of the cable modems on a cable interface after a switchover, as well
as the total time it takes for all cable modems to recover and come online. These messages also show the
total time it took the HCCP and DOCSIS protocol subsystems to synchronize after a switchover.
Router# debug cable interface c6/1/0
Router# debug cr10k-rp ha-msg
CR10K RP debug High Availability msg
PRE_HA_BUGMSG
PRE REDUNDANCY: Bulk sync completed
PRE REDUNDANCY: Recv bulk sync complete - sending ack
Cisco Broadband Cable Command Reference Guide
5-95
OL-1581-08
Advertisement
Table of Contents
