Table of Contents
Advertisement
show interface cable service-flow
show interface cable service-flow
To display the attributes of DOCSIS service flows on a given cable interface, use the show interface
cable service-flow command in privileged EXEC mode.
Syntax Description
slot/port
slot/subslot/port
sfid
classifiers [clid]
counters
phs
qos
verbose
Command Modes
Privileged EXEC
Command History
Release
12.1(4)CX
Cisco Broadband Cable Command Reference Guide
3-228
show interface cable {slot/port | slot/subslot/port} service-flow
show interface cable {slot/port | slot/subslot/port} service-flow sfid [classifiers | counters | phs |
qos] [verbose]
Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
•
•
•
(Optional) Identifies the service flow index (1 to 65535).
(Optional) Displays all classifiers associated with this service flow or
optionally display information only for the specified classifier ID (clid,
1 to 65535).
(Optional) Displays the real-time counters for the service flow for a specific
SFID.
(Optional) Displays packet header suppression rules and packet counters for
the service flow for a specific SFID.
Note
(Optional) Displays QoS information for the service flow for a specific
SFID.
(Optional) Displays detailed information on the service flow for a specific
SFID.
Modification
This command was introduced.
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
The PHS packet counters are not supported on the Cisco uBR-
MC5X20 card and always shows 0 or N/A, depending on the
software release.
Chapter 3
Cisco CMTS Show Commands
OL-1581-08
Advertisement
Table of Contents
