Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
snmp-server enable traps docsis-cmts
To enable the sending of Simple Network Management Protocol (SNMP) traps for DOCSIS-related
events, use the snmp-server enable traps docsis-cmts command in global configuration mode. To
disable the sending of traps, use the no form of this command.
Syntax Description
docsis-events
Defaults
No SNMP traps for DOCSIS-related events are enabled. When the snmp-server enable traps docsis-
cmts command is given without any options, all DOCSIS-related traps are enabled.
Command Modes
Global configuration
OL-1581-08
snmp-server enable traps docsis-cmts [docsis-events]
no snmp-server enable traps docsis-cmts [docsis-events]
Specifies one or more of the following DOCSIS event types:
bpi—Enables traps for BPI initialization failure events.
•
bpkm—Enables traps for BPKM failure events.
•
dccack—Enables traps for the failure of Dynamic Channel Change
•
Acknowledgement (DCC-ACK) requests.
dccreq—Enables traps for the failure of Dynamic Channel Change
•
Request (DCC-REQ) requests.
dccrsp—Enables traps for the failure of Dynamic Channel Change
•
Response (DCC-RSP) requests.
dsac—Enables traps for the failure of Dynamic Service
•
Acknowledgement (DSx-ACK) requests.
dsreq—Enables traps for the failure of Dynamic Service Request (DSx-
•
REQ) requests.
dsrsp—Enables traps for the failure of Dynamic Service Response
•
(DSx-RSP) requests.
dynsa—Enables traps for the failure of Dynamic Service Addition
•
(DSA-ACK) requests.
regack—Enables traps for the failure of Registration Acknowledgement
•
(REG-ACK) requests.
regreq—Enables traps for the failure of Registration Request (REG-
•
REQ) requests.
regrsp—Enables traps for the failure of Registration Response (REG-
•
RSP) requests.
snmp-server enable traps docsis-cmts
Cisco Broadband Cable Command Reference Guide
2-479
Advertisement
Table of Contents
