Table of Contents
Advertisement
cable qos enforce-rule
cable qos enforce-rule
To create an enforce-rule to be used to enforce a particular quality of service (QoS) profile for subscriber
traffic management, and to enter enforce-rule configuration mode, use the cable qos enforce-rule
command in interface configuration mode. To delete an enforce-rule and to remove it from the CMTS
configuration, use the no form of this command.
Syntax Description
rule-name
Defaults
This command has no defaults. By default, no enforce-rules are created.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.2(15)BC1
Usage Guidelines
The cable qos enforce-rule command creates an enforce-rule with the specified name and then enters
enforce-rule configuration mode. After entering enforce-rule configuration mode, use the following
subcommands to configure the enforce-rule:
•
•
•
•
•
•
At the very minimum, you must use the
commands to configure an enforce-rule, and the
Use the exit command to leave enforce-rule configuration mode and to return to global configuration
Tip
mode.
In Cisco IOS Release 12.2(15)BC1, you can create a maximum of 20 enforce-rules. If you have created
Note
20 enforce-rules and want to create another new rule, you must first delete one of the existing rules.
Otherwise, the CMTS displays an error message.
Cisco Broadband Cable Command Reference Guide
2-194
cable qos enforce-rule rule-name
no cable qos enforce-rule rule-name
Modification
This command was introduced.
activate-rule at-byte-count
enabled
enforced qos-profile
monitoring-duration
penalty-period
registered qos-profile
Name of the enforce-rule to be created and configured. This name can
be any arbitrary and unique string from 1 to 15 characters in length.
activate-rule at-byte-count
enabled
Chapter 2
Cisco CMTS Configuration Commands
and
registered qos-profile
command to activate it, before it takes effect.
OL-1581-08
Advertisement
Table of Contents
