Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Table 2-15 Switchover Operation for a Cisco uBR-MC16C/Cisco uBR-MC16S Configuration
Working Cable
Interface
Cisco uBR-MC16C Cisco uBR-MC16S The protect card (Cisco uBR-MC16S) uses the same
Cisco uBR-MC16S Cisco uBR-MC16C The protect card (Cisco uBR-MC16C) uses the same
Cisco uBR-MC16S Cisco uBR-MC16S The protect card initially uses the same upstream frequency
Examples
The following example configures host cable interface 4/0 to protect member 2 of group 2 at
IP address 1.1.11.2:
Router(config)# interface cable 4/0
Router(config-if)# hccp 2 protect 2 1.1.11.2
Related Commands
Command
cable downstream rf-
power
hccp working
show hccp
show hccp interface
OL-1581-08
Protect Cable
Interface
Operation After Switchover
upstream frequency as the working card, but after the
system stabilizes, the protect card begins using the
enhanced spectrum management features of the
Cisco uBR-MC16S card, as configured on the protect
CMTS.
upstream frequency as the working card. If the upstream
becomes unstable, the Cisco uBR-MC16C performs only
blind frequency hopping.
as the working card, but after the system stabilizes, the
protect card continues using the enhanced spectrum
management features of the Cisco uBR-MC16S card.
Description
Sets the RF power output level on a cable interface line card with an
integrated upconverter (including the ability to specify an override or delta
power value for a Protect interface).
Configures a specified cable interface to be a working member of a given
group.
Displays information for all cable interfaces on which one or more HCCP
groups and authentication modes have been configured.
Displays group information for a specific cable interface on which one or
more groups and authentication modes have been configured.
Cisco Broadband Cable Command Reference Guide
hccp protect
2-423
Advertisement
Table of Contents
